Removing Engine Carrier - GT2 RS
WARNING:
Danger of objects or loads falling down
- Risk of squashing or crushing
→ Secure components to prevent them from falling down.
Component overview
| Item | Designation | Explanation |
|---|---|---|
| 1 | Engine carrier | Clean and check for damage following removal. |
| 2 | Engine mounting (hydraulic mount) | Check for oil loss and damage. |
| 3 | Fastening screw, M8 x 60 | Tightening torque: 23 Nm (17 ft. lb.) |
| 4 | Adapter | |
| 5 | M12 collar nut | Tightening torque: 85 Nm (63 ft. lb.) |
| 6 | Holder for rear silencer | |
| 7 | External Torx screw, M10 x 70 | Tightening torque: 65 Nm (48 ft. lb.) |
- Support the engine using a transmission jack or engine retainer plate.
- Loosen and unscrew four M10 Torx screws. Remove holder for rear silencer.
- Loosen and screw off M12 collar nuts on the left and right engine mountings.
- Carefully lower the engine and remove the engine carrier from the threaded bolts on the engine mountings.
- Clean the carrier carefully with solvent naphtha and check for damage (e.g. cracks).
- Replace engine carrier if components are damaged.