Subsequent Work

→ Avoid contact with caustic fluid.

→ Wear personal protective gear.

→ Ensure that there is good ventilation.

→ If you do come into contact, wash off immediately with plenty of warm water and contact a doctor if necessary.

→ Secure components to prevent them from falling down.

→ Secure components to prevent them from falling down.

1. Raise the engine.

   Raise the engine into installation position with a jack, using Retainer Plate 9592  to do this.

   Screw in and tighten M12 collar nuts.

   → Tightening torque: 85 Nm (63 ft. lb.) 

2. Fill in coolant and bleed the system.

   → 193817 DRAINING AND FILLING COOLANT (INCLUDES BLEEDING) .

3. Install fuel filter.

   → 206019 REMOVING AND INSTALLING FINE FUEL STRAINER .

4. Install air cleaner housing.

   → 242519 REMOVING AND INSTALLING AIR CLEANER HOUSING .

5. Install pressure pipe.

   → 214119 REMOVING AND INSTALLING PRESSURE PIPE .

6. Perform a test drive, adjusting the coolant level in the container if necessary (note minimum/maximum marking).