Removing Charge-Air Cooler
- Remove rapid-action coupling from bottom of pressure hose and top of pressure hose by pulling the spring clamps -top arrow-
on the charge-air cooler.
- 1.1. Pull off hoses, check O-rings and replace them if necessary.
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
- Unscrew two hexagon-head bolts (M8 x 16) -left arrows-
and one M8 hexagon nut -top right arrow-
on the charge-air cooler bracket in the wheel housing.
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
- Unscrew one hexagon-head bolt (M8 x 16) -2-
, one M8 hexagon nut -1-
on the charge-air cooler bracket and one tapping screw at the rear side.
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
- Screw off two speed nuts (a/f 13) on the underside of the heat protection panel -arrows-
.
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
- Remove charge-air cooler module.