Subsequent Work

Install catalytic converter.
→ 267319 REMOVING AND INSTALLING CATALYTIC CONVERTER - TURBO ENGINE .
WARNING:
Danger of objects or loads falling down
- Risk of squashing or crushing
→ Secure components to prevent them from falling down.

Information
- It may only be supported over a large area at the oil pan.
- Localized loading is not permitted.
Secure the engine.
1. 2.1. Raise the engine using a transmission jack and move it into installation position.
2. 2.2. Fit and tighten two M12 collar nuts (internal Torx T55) on the rear engine mountings.
  → Tightening torque: 85 Nm (63 ft. lb.)
3. 2.3. Slowly lower the transmission jack and remove it from the work area.
Install heat shield on catalytic converter.
→ 635019 REMOVING AND INSTALLING REAR BUMPER .
Install charge air cooler.
→ 214319 REMOVING AND INSTALLING CHARGE AIR COOLER .
Install rear silencer.
→ 263319 REMOVING AND INSTALLING REAR SILENCER - TURBO .
Install rear apron.
→ 635519 REMOVING AND INSTALLING REAR APRON .