Preliminary Work And Notes On Assembly
- If the vibration damper is to be replaced, set the concave washer/height-adjusting nut -3-
to the same position as on the old vibration damper (copy the actual dimension -X-
to the new vibration damper).
A special tool hook wrench 9647 is required for this purpose.
The special tool hook wrench 9647 is required for changing the vehicle height (dimension -X- ).
The hook wrench 9647 is used together with a torque wrench to tighten the lock nuts (grooved nuts) -2- (tightening torque: 100 Nm (74 ftlb.)).
- 3 - Height-adjusting nut/lower concave washer (grooved nut)
- 2 - Lock nut (grooved nut)/tightening torque: 100 Nm (74 ftlb.)
- X - Pre-set dimension for production: 268.5 mm (plus/minus 1 mm). The dimension may be different for the prescribed vehicle height. If the vibration damper is to be replaced, the actual dimension must be set on the new vibration damper.