| Stabilizer to cross member, M10 x 60 |
Please note: Do not grease threaded connections in Dacromet finish - aluminum color. |
Tightening torque |
65 Nm (48 ftlb.) |
|
|
| Suspension/stabilizer mount to stabilizer, M10 |
Please note: Observe three-stage tightening procedure! Do not grease threaded connections in Dacromet finish - aluminum color. |
Three-stage tightening procedure (1st stage: tighten to 50 Nm (37 ftlb.). 2nd stage: loosen by 90 degrees. 3rd stage: tighten to 65 Nm (48 ftlb.). |
65 Nm (48 ftlb.) |
|
|
| Suspension/stabilizer to shock absorber pipe/wheel carrier, M12 x 1.5 (911 Carrera/911 GT3) |
Please note: Do not grease threaded connections in Dacromet finish - aluminum color. |
Tightening torque |
85 Nm (63 ftlb.) |
|
|
| Suspension/stabilizer to spring strut plate, M10 (911 Carrera 4) |
Please note: Do not grease threaded connections in Dacromet finish - aluminum color. |
Tightening torque |
65 Nm (48 ftlb.) |
|
|