| Control arm to cross member/side member, M12 x 1.5 |
Please note: Do not grease threaded connections in Dacromet finish - aluminum color. |
Tightening torque |
120 Nm (89 ftlb.) |
|
|
| Control arm to diagonal arm, M14 x 1.5 |
Please note: Do not grease threaded connections in Dacromet finish - aluminum color. |
Tightening torque |
160 Nm (118 ftlb.) |
|
|
| Control arm to wheel carrier (ball joint), M12 x 1.5 (also applicable for 911 GT3) |
Please note: Do not grease threaded connections in Dacromet finish - aluminum color. |
Tightening torque |
75 Nm (56 ftlb.) |
|
|
| Camber basic setting on two-part trailing arm, M8 (911 GT3) |
Please note: Do not grease threaded connections in Dacromet finish - aluminum color. |
Tightening torque |
27 Nm (20 ftlb.) |
|
|