LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2011 >> 911 Speedster >> Repair and Diagnosis >> Drivelines & Axles >> Wheel Hubs >> 40 - Front Wheel Suspension, Drive Shafts -- CARRERA (997) >> WM 400119 Removing And Installing Front Axle (All Models) >> Removing And Installing Front Axle >> Subsequent Work

Subsequent Work

  1. Fill the steering hydraulic system with Pentosin and top up the fluid level in the cooling system.

    Then bleed the steering and cooling system.

    → 480201 CHECKING THE FLUID LEVEL FOR POWER STEERING

    → 193817 DRAINING AND FILLING IN COOLANT (INCLUDES BLEEDING THE SYSTEM)

    Information 

    When topping up or filling in Pentosin, make sure that it does not come into contact with the coolant hoses. Observe the specifications in order to avoid overfilling, and thus overflowing.

    • If coolant hoses come into contact with Pentosin, clean them thoroughly with water IMMEDIATELY. 
    • Replace visibly swollen coolant hoses. 
    • Tighten all threaded connections to the specified tightening torque. 
  2. Install front wheels.

    → 440519 REMOVING AND INSTALLING WHEEL

  3. Install front underbody panels.

    → 519219 REMOVING AND INSTALLING COVER FOR FRONT UNDERBODY

  4. Perform suspension alignment.

    → 449503 SUSPENSION ALIGNMENT, COMPLETE

scientia non olet · About LEMON Manuals