LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2011 >> 911 Speedster >> Repair and Diagnosis >> Drivelines & Axles >> Driveshaft & Universal Joints >> 42 - Rear Wheel Suspension, Drive Shafts -- CARRERA (997) >> WM 425219 Removing And Installing Rear Wheel Bearing Housing (Wheel Carrier) (Except 911 Turbo S Coupe "Ed. 918 SPYDER", 911 CARRERA 4 GTS, 911 CARRERA 4 GTS CABRIO, 911 Gt3 RS 4.0) >> Subsequent Work

Subsequent Work

  1. Fit wheel → INSTALLING WHEEL .
  2. Tighten axle nut (drive shaft to wheel bearing housing) if it was removed (vehicle lowered, brakes operated by 2nd fitter).

    → Tightening torque: 460 Nm (340 ftlb.) 

  3. Check wheel alignment values and adjust if necessary. → 449503 PERFORMING FRONT AND REAR SUSPENSION ALIGNMENT .
scientia non olet · About LEMON Manuals