LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2011 >> 911 Speedster >> Repair and Diagnosis >> Drivelines & Axles >> Driveshaft & Universal Joints >> 42 - Rear Wheel Suspension, Drive Shafts -- CARRERA (997) >> WM 423819 Removing And Installing Rear-Axle Carrier Side Section (Except 911 Turbo S Coupe "Ed. 918 SPYDER", 911 CARRERA 4 GTS, 911 CARRERA 4 GTS CABRIO, 911 Gt3 RS 4.0) >> Removing And Installing Rear-Axle Carrier Side Section >> Removing Rear-Axle Carrier Side Section

Removing Rear-Axle Carrier Side Section

Fig 1: Overview Of Rear-Axle Carrier Side Section
G09825685Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  1. Rear-axle carrier side section
  2. Lock nut
  3. Washer
  4. Stud, M12
  5. Elastic bolt, M12
  6. Screw, M12
  7. Lock nut, M12
  8. Transverse strut
  9. Screw, M10
  10. Diagonal brace
  11. Rubber mount
  12. Screw
  13. Screw
  14. Cross member
  15. Screw
  16. Lock nut
  17. Sensor
  18. Brake hose bracket
  19. Screw, M6
  1. Loosen drive shafts on the transmission side.
    1. 1.1. Counter using special tool adapter plate 9510/1  (-1-  ).
      Fig 2: Identifying Retaining Tool For Drive-Shaft Bolts
      G09825686Courtesy of PORSCHE CARS NORTH AMERICA, INC.

      Information 

      • Protect the drive shafts from mechanical damage. 
    2. 1.2. Unscrew the six bolts between the drive shaft and transmission flange.
      Fig 3: Identifying Drive Shaft
      G09825687Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  2. Remove anti-roll bar on rear-axle carrier side section -1-  .
    Fig 4: Removing Anti-Roll Bar
    G09825688Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  3. Mark eccentric threaded joints (toe and transverse control arms) on the rear-axle carrier side section.
    1. 3.1. Mark the position of the toe and camber eccentrics on the rear-axle carrier side section -arrows-  .
      Fig 5: Locating Eccentric Threaded Joint
      G09825689Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  4. Remove transverse strut.

    Unscrew screws and remove transverse strut.

    Information 

    • When raising the vehicle, take care to maintain access to the screws for the diagonal struts in the vicinity of the rear jacking points. 
  5. Remove right and left diagonal braces -10-  .

    Unscrew screws -12, 13-  and lock nuts (collar nuts) on the rear-axle carrier side sections. Remove right and left diagonal braces -10-  .

    Fig 6: Identifying Diagonal Brace
    G09825690Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  6. Remove the cross member -14-  .
    1. 6.1. Loosen nuts on the bottom threaded joint (M12 x 80) and pull out the bolts.
    2. 6.2. The top threaded joint -15, 16-  (M12 x 80) only needs to be loosened because of the slots.
    3. 6.3. Remove the cross member -14-  .
      Fig 7: Identifying Cross Member
      G09825691Courtesy of PORSCHE CARS NORTH AMERICA, INC.
      Fig 8: Locating Cross Member Mount, Top
      G09825692Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  7. Remove brake hose bracket on the rear-axle carrier side section.
  8. Remove diagonal arm -17-  .
    1. 8.1. Remove diagonal arm -17-  at the wishbone -21-  . To do this, loosen and unscrew the bolts -19, 20-  .
    2. 8.2. Remove diagonal arm -17-  at the rear-axle carrier side section -1-  . To do this, loosen and unscrew the bolts -18, 19-  .
    3. 8.3. Remove diagonal arm -17-  .
    Fig 9: Identifying Removing\Installing Components Of Diagonal Arm
    G09825693Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  9. Remove upper control arm -8-  .

    Remove both control arms -8-  at the rear-axle carrier side section. To do this, loosen and unscrew bolts -9, 10-  and -11, 12-  .

    Fig 10: Identifying Upper Control Arms Components
    G09825694Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  10. Remove lower control arms -13, 21-  .

    Remove both control arms -13, 21-  at the rear-axle carrier side section. To do this, loosen and unscrew the bolts -12, 15, 22-  .

    Fig 11: Identifying Lower Control Arms Components
    G09825695Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  11. Remove rear-axle carrier side section -1-  .

    Unscrew lock nut -7-  , screws -5, 6-  and remove rear-axle carrier side section -1-  .

    Fig 12: Identifying Rear-Axle Carrier Side Section
    G09825696Courtesy of PORSCHE CARS NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals