Preliminary Work

→ Do not place any solid objects under the raised vehicle.

→ Ensure that the lifting platform is prevented from lowering.

→ Remove solid objects before lowering the vehicle.

→ Raise the vehicle only at the jacking points provided.

→ The outer jacking points should be used primarily.

1. Jack and raise the vehicle at the prescribed jacking points.

   → WM 4X00IN LIFTING THE VEHICLE (ALL MODELS)

2. Remove underbody panelling.

   → WM 519419 REMOVING AND INSTALLING COVER FOR REAR UNDERBODY - section on "Removing"

   → WM 519319 REMOVING AND INSTALLING COVER FOR CENTRE UNDERBODY - section on "Removing"

   → WM 519219 REMOVING AND INSTALLING COVER FOR FRONT UNDERBODY - section on "Removing"

3. Remove the cardan shaft.

   → 390219 REMOVING AND INSTALLING CARDAN SHAFT  - section on "Removing"

4. Remove front final drive.

   → 398819 REMOVING AND INSTALLING FRONT FINAL DRIVE  - section on "Removing"

5. Drain oil for front final drive.

   → 399055 CHANGING OIL FOR FRONT FINAL DRIVE  - section on "Draining"