LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2011 >> 911 Speedster >> Repair and Diagnosis >> Drivelines & Axles >> Axle Shafts >> 42 - Rear Wheel Suspension, Drive Shafts -- CARRERA (997) >> WM 429019 Removing And Installing Rear Anti-Roll Bar (Except 911 Turbo S Coupe "Ed. 918 SPYDER", 911 CARRERA 4 GTS, 911 Turbo S CABRIO "Ed. 918 SPYDER", 911 CARRERA 4 GTS CABRIO, 911 Gt3 RS 4.0) >> Removing Anti-Roll Bar

Removing Anti-Roll Bar

  1. Raise the vehicle at the specified jacking points → 4X00IN01 LIFTING THE VEHICLE .
  2. Remove rear anti-roll bar.
    1. 2.1. Unscrew two fastening screws -1-  . Repeat procedure on the other side of the vehicle.
    2. 2.2. Unscrew one hexagon nut (at the left and right) -2-  . Counter at the inner Torx screw on the suspension/stabilizer (connecting link) while doing this.
    3. 2.3. Remove the anti-roll bar.
      Fig 1: Removing Anti-Roll Bar
      G09825784Courtesy of PORSCHE CARS NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals