LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2011 >> 911 Speedster >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> 47 - Brakes - Hydraulic Brake System, Regulator -- CARRERA (997) >> WM 474119 Removing And Installing Rear Brake CALLIPER (Turbo Coupe, Turbo S Coupe, Turbo CABRIO, Turbo S CABRIO, Gt3, Gt2, Gt3 RS, Gt2 RS) >> Installing rear brake calliper (standard brake system and PCCB)

Installing rear brake calliper (standard brake system and PCCB)

  1. Fit brake calliper on wheel carrier. Use new fastening screws -3-  . Tightening torque: 85 Nm (63 ftlb.).

    Fit brake line -1-  and holder (M6 screw) -2-  on brake calliper.

    Tightening torques: Brake line -1-  = 12-14 Nm (9-10.5 ftlb.)/holder (M6 screw) -2-  = 10 Nm (7.5 ftlb.).

    Fig 1: Identifying Brake Calliper/Brake Line
    G09826274Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
  2. Route brake pad wear indicator wire (clip it into the holders) and connect the connector to the combination plug connection. Lock combination plug connection.
  3. Bleed the brake system and adjust the brake-fluid level → 470107 BLEEDING THE BRAKE SYSTEM .
scientia non olet · About LEMON Manuals