Installing Rear Window Cover

Install rear window cover.
1. 1.1. Position rear window cover -1- on the hinges -4- and place a shim -5- between the rear window cover -1- and hinge -4- .
2. 1.2. Screw on fastening screws -2- hand-tight.
3. 1.3. Move the rear window cover -1- at the hinges -4- to adjust the contours with respect to the sliding roof cover and rear center panel. → Gap dimension A: 15 mm+/-2 mm → Gap dimension A: 6 mm+/-1 mm → Gap dimension B: 2 mm+/-1 mm → 5000IN DIAGRAM - BODY GAP DIMENSIONS
4. 1.4. Adjust the parallel positioning -Arrows A- of the upper edge of the hinge -4- with respect to the fastening screws -2- . Tighten fastening screws -2- and fastening nuts -3- . → Tightening torque: 10 Nm (7.5 ftlb.) → Tightening torque: 4 Nm (3.0 ftlb.)
  
  Fig 1: Installing Rear Window Cover
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Adjust rear window cover.
1. 2.1. Adjust the height of the rear window cover with respect to the rear center panel by screwing the rubber adjustment stops -1- at the left and right in or out as required. → Gap dimension: 6 mm+/-1 mm → 5000IN DIAGRAM - BODY GAP DIMENSIONS
  
  Fig 2: Screwing In Rubber Adjustment Stop
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.