Fitting Swivel And Support Cheeks On The Basic Plate

Basic material: Wood-core plywood 1500 x 900 mm, 19 mm thick

Fig 1: Identifying Swivel And Support Cheeks Dimensions

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

1. -A3-  = Base
2. -B-  = Support cheek
3. -C-  = Swivel arm
4. -D-  = Base plate

1. Work procedure: 
   1. 1.1. During assembly, all parts are positioned from the center!
   2. 1.2. Measure and mark the plate -D-  .
   3. 1.3. Fasten completed swivel arm -C-  on the hinge -A2-  with four 4.5 x 20 countersunk screws in accordance with the dimensions specified on the plate -D-  .
   4. 1.4. Transfer hole pattern of the support cheeks -B-  onto the base plate -D-  in accordance with the specified dimensions, and drill holes using a 6-mm drill bit.
   5. 1.5. Fit support cheeks -B-  over the prefitted straight pins -A4-  onto the plate -D-  .