Technical Values
| Location | Description | Type | Basic value | Tolerance 1 | Tolerance 2 |
|---|---|---|---|---|---|
| Top of side panel to rule | Adjustment value A | 50 mm | |||
| Rear side panel (rule or aluminum section) to center of assembly aid peg | Adjustment value | 139 mm | |||
| Centre of assembly aid peg to lower edge of convertible-top peg housing on inside | Adjustment value | 1070 mm | |||
| Diagonal dimension of styling edge | Adjustment value D | 1024 mm | +/-2 mm | ||
| Adjust tension cable | Adjustment range | approx. 15 mm |