Preparing Mounting Unit (Drive Mechanism) For Installation

Information

To ensure the functioning of the drive mechanism, the replacement parts included in the scope of delivery must always be replaced.

Assemble front mount.
Information

The bigger collar -arrow- on the sliding pad must always face upwards.
1. 1.1. Insert sliding pad -2- into the mounting plate -1- .
2. 1.2. Insert front mount slide -3- into the sliding pad -2- .
  Information
  
  Make sure that the drive shaft runs below the mount slide.
3. 1.3. Insert drive shaft connection -4- into the front mount slide -3- in -direction of arrow- .
  
  Fig 1: Assembling Front Mount
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Assemble rear mount.
Information

Make sure that the drive shaft runs below the mount slide.
1. 2.1. Insert front drive shaft connection -2A- into the rear mount slide -1- in -direction of arrow- .
  Information
  
  The clamp jaw is a safety component, which blocks the frame for the sliding roof cover when the drive shaft connections are broken.
2. 2.2. Insert rear drive shaft connection -2B- between the clamp jaw -3- in -direction of arrow- .
  
  Fig 2: Assembling Rear Mount
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.