Tools And Materials

Information 

• The following assembly fixtures must be made for the adjustment operations at the mounting unit. 

1. The following tools and materials are required for making the adjustment devices:
   1. 1.1. Sabre saw 00000 
   2. 1.2. Measuring tape 00000 
   3. 1.3. Commercially available hardwood block 00000 
2. Make adjustment block for left holder.
   1. 2.1. Make hardwood adjustment block -1 L-  with the corresponding specified dimensions.
      1. 64 mm
      2. 40 mm
      3. 32 mm
      4. 62 mm
      Fig 1: Identifying Left Holder Adjustment Block Dimensions

      Courtesy of PORSCHE CARS NORTH AMERICA, INC.
3. Make adjustment block for right holder.
   1. 3.1. Make hardwood adjusting device -1 R-  with the corresponding specified dimensions.
      1. 64 mm
      2. 40 mm
      3. 32 mm
      4. 64 mm
      Fig 2: Identifying Right Holder Adjustment Block Dimensions

      Courtesy of PORSCHE CARS NORTH AMERICA, INC.