Assembling Roof Assembly Frame
- Press rubber grommet for water drain -1-
at the front left and right into the roof assembly frame.
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
- Position lid hinge -1-
on the roof assembly frame and secure with fastening nuts -2-
. → Tightening torque: 10 Nm (7.5 ftlb.)
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
- Fit seal for rear window cover -1-
all the way around in -direction of arrow-
on the roof assembly frame flange.
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
- Pull seal for the center joint -1-
into the roof assembly frame in -direction of arrow-
. The seal for the center joint -1-
must be flush on the left and right.
Courtesy of PORSCHE CARS NORTH AMERICA, INC.