LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2011 >> 911 Speedster >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> 63 - Bumpers -- CARRERA (997) >> WM 635519 Removing And Installing Rear Apron (Turbo Coupe, Turbo S Coupe, Turbo CABRIO, Turbo S CABRIO, Gt2, Gt2 RS) >> Removing rear apron

Removing rear apron

Fig 1: Identifying Installation Position Of Rear Apron
G09824772Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  1. Unscrew expanding pin -1-  and unclip the expanding clip -2-  .
    Fig 2: Identifying Expanding Clip
    G09824773Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  2. Unscrew fastening screws -1-  at the sides of the rear apron -2-  .
    Fig 3: Identifying Rear Apron At Sides
    G09824774Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  3. Check speed nuts -3-  and replace them if necessary.
  4. Unscrew fastening screws -1-  at the top and bottom of the rear apron -2-  .
    Fig 4: Detaching Rear Apron At Top And Bottom
    G09824775Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Information 

    Two people are needed to remove and install the rear apron!

  5. Pull rear apron -2-  carefully to the rear until the plug connection can be reached.
  6. Press locking lug on plug connection -1-  (-arrow A-  ) and disconnect it -arrow B-  .
    Fig 5: Disconnecting Plug Connection
    G09824776Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  7. Remove the rear apron.Removing rear apron