Removing sealing rubber

Fig 1: Overview Of Rear Lid

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Heat the bonding area of the sealing rubber -1- using the hot-air blower v.a.g 1416 .

Fig 2: Identifying Rubber Cover
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Insert a plastic wedge between the rear lid and sealing rubber -1- and loosen the bonded joint.
Remove adhesive residue on the rear lid using the film eraser Nr.174 Pos.1 and holder Nr.174 Pos.2 .
Remove adhesive residue from the sealing rubber and clean with isopropanol.