LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2011 >> 911 Speedster >> Repair and Diagnosis >> Accessories & Equipment >> Wiring System (Data Link Connectors, Pwr Dist., Grnd Dist.) >> 97 - Cables -- CARRERA (997) >> WM 977223 Installing Optical WAVEGUIDE (All Models) >> Installing Optical Waveguide >> Disconnecting Optical Waveguide

Disconnecting Optical Waveguide

Information 

Observe the general information on optical waveguides. → General information on optical waveguides - MOST bus 

NOTE: Voltage peaks
  • Risk of damage to load or to the control unit

→ Remove the ignition key and switch off load before disconnecting or removing load.

  2. Release the connectors of the damaged optical waveguides on the affected components -arrow a-  and disconnect them. The illustration shows the connector on the CD changer as an example.
    Fig 1: Disconnecting Connector For Optical Waveguide
    G09831527Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  3. Cut off the connector of the damaged optical waveguide, isolate it and tie it to the main wire harness.
scientia non olet · About LEMON Manuals