Installing KESSY/PAS control unit

→ Remove the ignition key and switch off load before disconnecting or removing load.

→ Remove the ignition key and switch off load before disconnecting or removing load.

Information 

Depending on the vehicle equipment, the control unit has one or two connectors.

1. Press both electrical connectors -1, 2-  into the control unit and lock them until they are felt to engage.
   Fig 1: Installing Electrical Connectors

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
2. Engage control unit in support for wiring harness with both retaining lugs.
   Fig 2: Installing Control Units

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
3. Clip in control unit on the support for the steering wiring and engage the locking mechanism for the lock.
   Fig 3: Installing Control Unit And Pivoting Out Securing Bolt

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.