Assembling remote control

Information 

In the event of a complaint (remote control buttons too easily pressed), the silicone pad and buttons can be replaced with modified spare parts.

1. Engage new buttons in the remote control housing.
   Fig 1: Installing Remote Control Housing Buttons

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Information 

   The PCB should only be held carefully at the edge.

   Immediately after removal, insert the PCB back into the silicone pad and assemble the remote control.

2. Insert PCB -2-  into the new silicone pad -1-  .
   Fig 2: Identifying PCB And Silicon Pads

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
3. Insert silicone pad -1-  with PCB into the remote control housing.
   Fig 3: Installing Silicon Pad Into Remote Control Housing

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
4. Position the cover on the bottom part of the remote control and press together until the cover clicks into place.
   Fig 4: Installing Remote Control Cover

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
5. Test the remote control by pressing all the buttons one after the other.