Installing Front Control Unit

→ Remove the ignition key and switch off load before disconnecting or removing load.

→ Remove the ignition key and switch off load before disconnecting or removing load.

1. Insert the front control unit into the body and secure with the fastening nut -2-  . → "TECHNICAL VALUES " → Tightening torque: 9.7 Nm 
   Fig 1: Attaching Control Unit

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
2. Push in the electrical connector and lock it so that it is felt to engage.
   Fig 2: Plugging In Electrical Connector

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
3. Clip in left and right electric lines on the control unit.
4. Position the cover -1-  and push it in until it snaps into place in the four clips.
5. Screw down cover with the fastening screw -3-  .
Fig 3: Positioning Cover
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
6. If a new control unit has been installed, it must be programmed to the vehicle. → Coding Control Unit