Technical Values
WARNING: This page is about a different variant/trim than selected.
| Location | Description | Type | Basic value | Tolerance 1 | Tolerance 2 |
|---|---|---|---|---|---|
| Position of unit lifting platform with respect to engine | Position of unit lifting platform with respect to engine | Adjustment value | 10° | ||
| Distance between engine and anti-roll bar | Control value | 10 mm | |||
| Screws securing transmission to engine housing | M12 x 55 | Tightening torque | 85 Nm (63 ftlb.) | ||
| Screw for solenoid valve | M6 x 12 | Tightening torque | 10 Nm (7.5 ftlb.) | ||
| Screw for speed sender | M6 x 15 | Tightening torque | 10 Nm (7.5 ftlb.) | ||
| Gear support to manual transmission | M10 x 1.5 - do not grease. | Tightening torque | 65 Nm (48 ftlb.) | ||
| Hydraulic mount to rear-axle carrier side section | M8 - do not grease. | Tightening torque | 33 Nm (24 ftlb.) | ||
| Anti-roll bar to side section | M8 x 40 - do not grease. | Tightening torque | 23 Nm (17 ftlb.) | ||
| Screws securing drive shaft to halfshaft flange | M10 | Tightening torque | 81 Nm (60 ftlb.) | ||
| Screws securing cross member to body | M10 x 72 | Tightening torque | 65 Nm (48 ftlb.) | ||
| Support plate to cross member | M10 x 1.5 - do not grease. | Tightening torque | 65 Nm (48 ftlb.) | ||
| Support plate to cross member (V-strut) | M10 x 1.5 - do not grease. | Tightening torque | 65 Nm (48 ftlb.) | ||
| Diagonal brace with support plate to carrier side section | M10 x 25 - do not grease. | Tightening torque | 65 Nm (48 ftlb.) | ||
| Diagonal brace to body | M12 - do not grease. | Tightening torque | 110 Nm (81.5 ftlb.) |