Installing Water Drip Pan: Overview

WARNING: This page is about a different car, the 2012 Porsche Boxster, 2011 Porsche Boxster, 2010 Porsche Boxster, 2009 Porsche Boxster, and 2008 Porsche Boxster. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Installation Position Of Water Drip Pan

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Insert water drip pan -1- behind the convertible top support -2- from below -arrows- .
Position water drip pan -1- on the roll-over bar and press onto the two strips of double-sided adhesive tape -3- close to the fastening for the convertible top support.

Fig 2: Installing Water Drip Pan
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
NOTE:
Incorrect handling of tools
- Risk of damage to the body
→ Only use tools approved by Porsche.

→ Always ensure that the tool is seated correctly.

→ Protect the body and interior of the vehicle from damage with protective covers.

→ Cover delicate components with cardboard or sheetmetal panels.
NOTE:
Incorrect handling of tools
- Risk of damage to the body
→ Only use tools approved by Porsche.

→ Always ensure that the tool is seated correctly.

→ Protect the body and interior of the vehicle from damage with protective covers.

→ Cover delicate components with cardboard or sheetmetal panels.
Remove spacing block -1- between the roll-over bar and convertible-top support -2- (-arrow A-).
Position convertible top support -2- on the roll-over bar -arrow B- and secure with the three fastening screws -3- . Tightening torque → Tightening torque: 23 Nm (17 ftlb.)

Fig 3: Securing Convertible Top Support

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Place the belt reel -1- on the roll-over bar -arrow- , position it correctly and secure with the fastening screw -2- . Tightening torque → Tightening torque: 50 Nm (37 ftlb.)

Fig 4: Installing Belt Reel
Courtesy of PORSCHE CARS NORTH AMERICA, INC.