Removing Countershaft Cap

WARNING: This page is about a different variant/trim than selected.

Fig 1: Locating Countershaft Cap

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Drive two small holes -figure- - offset by 180 degrees - into the sealing ring.

Fig 2: Drilling Hole Into Sealing Ring
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Screw two sheetmetal screws into the holes in the cap.

Fig 3: Locating Sheetmetal Screws
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Remove cap using slide hammer kit nr.168.

Fig 4: Removing Sealing Ring
Courtesy of PORSCHE CARS NORTH AMERICA, INC.