Preparations For Assembly

1. Place the cap -1-  , rubber stop -2-  and protective sleeve -3-  together as follows before pushing them on to the piston rod:
   Fig 1: Identifying Assembling Cap, Rubber Stop And Protective Sleeve

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
   • Push the rubber stop -2-  up fully into the protective sleeve -3-  .
   • Insert the cap into the protective sleeve -see Fig 2- and pull the lip carefully over the cap.
     Fig 2: Identifying Fitting Cap Into Protective Sleeve

     Courtesy of PORSCHE CARS NORTH AMERICA, INC.
2. Place the bottom concave washer -see Fig 3- together with the bottom support -see Fig 3- at the correct position (not twisted).
   Fig 3: Fitting Bottom Concave Washer Into Bottom Support

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   At the correct position means that the two individual parts are fitted precisely together.

3. Place the top concave washer -1-  together with the top support -2-  at the correct position (not twisted).
   Fig 4: Identifying Top Concave Washer With Top Support

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

At the correct position means that the two individual parts are fitted precisely together.