| -A- |
Tubular piston cylinder VAS 6178 |
The tubular piston cylinder is used together with the pneumatic hydraulic pump VAS 6179. |
| →
see Figure Tool set T10230 |
Assembly fixture T10230 |
Tool set for pressing hydraulic mount/rubber-metal mount in and out, consisting of No. 1-15. |
| -1- |
Threaded rod - assembly fixture T10230 |
Used in the tubular piston cylinder VAS 6178 -A-
. |
| -2- |
Nut with collar - assembly fixture T10230 |
Screwed onto the threaded rod -1-
. |
| -3- |
Spacer sleeve 180 - assembly fixture T10230 |
For pressing the bearing out and in. |
| -4- |
Pressure piece 40 - assembly fixture T10230 |
For pressing out the bearing. |
| -5- |
Pipe 56 - assembly fixture T10230 |
For pressing out the bearing. |
| -6- |
Pressure disc - assembly fixture T10230 |
For pressing the bearing out and in. |
| -7- |
Adjusting washer - assembly fixture T10230 |
Screwed into the tubular piston cylinder VAS 6178 -A-
with two countersunk screws. |
| -8- |
Support 55 - assembly fixture T10230 |
For pressing in the bearing. |
| -13- |
Pressure head - assembly fixture T10230 |
Pressure head from assembly fixture T10205 (!); screwed into the tubular piston cylinder VAS 6178 -A-
. |
| -14- |
Washer |
Placed on the threaded rod -1-
. |
| -15- |
Nut |
Commercially available M14 nut. Screwed onto the threaded rod -1-
. |