Removing Tire Pressure Monitoring (TPM) Antenna
Information
The antenna for the Tire Pressure Monitoring (TPM) system is located on the underside of the vehicle on the side member.
Information
For offroad package only.
- Remove cap.
- 1.1. Unscrew fastening screws -1- from the clip nuts -3- .
- 1.2. Remove cap -2- (-arrow- ).
- Remove TPM antenna.
- 2.1. Release connector -1- (-arrow A- ) and pull it off -arrow B- .
- 2.2. Unscrew fastening screws -2- and remove TPM antenna -3- (-arrow C- ).
- Remove support for TPM antenna.
- 3.1. Release support -1 and 2- at the locking tabs -arrows A- and remove from the TPM antenna -2- (-arrows B- ).