Belt Tensioner
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
- Purple marking on the connector - adapter for 1st stage of head, side, passenger's airbag units and belt tensioner
- Marking A - adapter for 1st stage of driver's airbag unit
- Marking B - adapter for 2nd stage of driver's airbag unit
- Green marking on the connector - adapter for 2nd stage of passenger's airbag unit
- Adapter for ignition device
- For the front belt tensioners, remove the B-pillar trim panel. → Removing B-pillar trim panel
- For the rear belt tensioners, remove the C-pillar trim panel and the rear side-panel lining. → Removing C-pillar trim panel
→
Removing rear luggage compartment side-trim panel
- Unplug the connector on the seat-belt tensioner and insert connector -A-
from the adapter cable 92574
.
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
- Connect the detonator 92570
to the 2-pin connector -E-
of the adapter cable 92574
.
- Place the ignition device in front of the vehicle through the door gap.