Subsequent Work

Gap dimensions of tailpipe 

→ Observe exact gap dimensions.

→ After the test drive, check the gap dimensions again and re-adjust if necessary.

• Check gap dimensions of tailpipe with respect to rear apron and adjust tailpipe if necessary. → 263419 REMOVING AND INSTALLING TAILPIPES ON DFI ENGINES
• V8 S/V6 tailpipe 

  → Gap dimension X: 18 mm 

  → Gap dimension Y: 20 mm 

  Fig 1: [Identifying Gap Dimensions Of Tailpipe With Respect To Rear Apron]

  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
• V8 Sport/V8 Turbo tailpipe 

  → Gap dimension X: 18 mm 

  → Gap dimension Y: 20 mm 

  Fig 2: Identifying Gap Dimensions Of Tailpipe With Respect To Rear Apron

  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
• V8 Exclusive tailpipe 

  → Gap dimension X: 7 mm 

  → Gap dimension Y: 7 mm 

  Fig 3: Identifying Gap Dimensions Of Tailpipe With Respect To Rear Apron

  Courtesy of PORSCHE CARS NORTH AMERICA, INC.

1. Adjust gap dimensions.
   1. 1.1. Close the lid.
   2. 1.2. Check gap dimensions at the lid. → 5000IN DIAGRAM - BODY GAP DIMENSIONS
   3. 1.3. Remove rear apron if necessary, loosen fastening nuts -1-  and -3-  , and adjust gap dimensions by moving the rear retaining strip -2-  and the retaining bracket -4-  . → Tightening torque: 8 Nm (6 ftlb.)+/-1 Nm (+/-0.5 ftlb.) 
      Fig 4: Installing Rear Retaining Strip And Retaining Bracket

      Courtesy of PORSCHE CARS NORTH AMERICA, INC.
2. Check gap dimensions of tailpipe with respect to rear apron and adjust tailpipe if necessary. → Subsequent Work 

   Information 

   • Only for vehicles with externally fitted spare wheel. 
3. Install spare wheel mount.
4. Install tail lights → 943119 REMOVING AND INSTALLING TAIL LIGHTS