Installing front bumper

Fig 1: Identifying Installation Position Of Front Bumper

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Install bumper.
1. 1.1. Install bumper -11- and position it correctly -arrow- .
2. 1.2. Screw in fastening screws -9, 10- (-arrows- ) but do not tighten them and check the position of the bumper.
3. 1.3. Tighten fastening screws -9, 10- to the specified tightening torque.
  → Tightening torque: 1.5 Nm (1.0 ftlb.)+/-0.5 Nm (+/-0.5 ftlb.) → Tightening torque: 65 Nm (48 ftlb.)+/-10 Nm (+/-7.5 ftlb.)
4. 1.4. Remove piece of wood from between radiator and transverse bar.
  
  Fig 2: Installing Bumper Fastening Screws
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Plug in connector on horn at the left and right and clip in wire harness.
1. 2.1. Plug in connector on horn -arrow A- until it engages securely.
2. 2.2. Clip in wire harness at the left and right of the bumper -arrow B- .
  
  Fig 3: Plugging Horn Connector Wire Harness
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Install the side air guide.
1. 3.1. Cayenne/Cayenne S :
  Position side air guide -5- (-arrow- ) and secure with fastening screws -4- (-arrow- ).
  
  Tighten fastening screws -4- to the specified tightening torque. → Tightening torque: 1.5 Nm (1.0 ftlb.)+/-0.5 Nm (+/-0.5 ftlb.)
  
  Fig 4: Installing Side Air Guide
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Fasten lock support.
1. 4.1. Align the lock support with the bumper.
2. 4.2. Screw in fastening screw -1- but do not tighten it, and re-check the position of the lock support with respect to the bumper.
3. 4.3. Tighten fastening screw -1- to the specified tightening torque.
  → Tightening torque: 9 Nm (6.5 ftlb.)+/-1 Nm (+/-0.5 ftlb.)
  
  Fig 5: Identifying Lock Support
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Connect radiator module.
1. 5.1. Install plastic guide element -1- (-arrow- ).
2. 5.2. Position fastening clamp -2- and hook it in -arrow- .
  
  Fig 6: Installing Radiator Module
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.