LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2010 >> Boxster Base, Standard >> Repair and Diagnosis >> Accessories & Equipment >> Wiring System (Data Link Connectors, Pwr Dist., Grnd Dist.) >> 97 - Cables -- 987-BOXSTER-CAYMAN >> WM 972519 Removing And Installing Rear Wire Harness (All Models) >> Installing Rear Wire Harness

Installing Rear Wire Harness

Fig 1: Identifying Plugs For Rear Wire Harness
G09606204Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  1. Install rear wire harness.
    1. 1.1. Lay out rear wiring harness.
    2. 1.2. Insert rear wire harness in the four holders -14-  at the end plate.
    3. 1.3. Clip rear wire harness at the left and right at both retaining clips -13-  into the rear vent.
    4. 1.4. Fit rubber sleeve -12-  .

      Information 

      Only in the Boxster.

  2. Pushing on connector on sender for coolant-level indicator -10-  .
    1. 2.1. Push on connector on sender for coolant-level indicator -arrow-  until it is felt to engage.
    2. 2.2. Clip in rear wire harness at both holders -11-  .
    Fig 2: Installing Coolant-Level Indicator Connector
    G09593844Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  3. Push the plug connection for the rear lid lock together until it is felt to engage. → Installing Lower Part Of Lid Lock At Rear
  4. Press plug connection for spoiler drive engine together until it is felt to engage. → 667219 REMOVING AND INSTALLING SPOILER DRIVE
  5. Secure ground point -5-  .
    1. 5.1. Connect ground straps and screw down fastening nut. → Tightening torque: 9 Nm (6.5 ftlb.) 
    Fig 3: Securing Ground Point
    G09593845Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  6. Push on connector for rear light at the left and right until it is felt to engage. → WM 943119 REMOVING AND INSTALLING TAIL LIGHT (ALL MODELS)
  7. Push together plug connections for rear wire harness to main wire harness -2 and 3-  .
    1. 7.1. Push connector sockets for rear wire harness onto relay carrier -arrows A-  until they are felt to engage.
    2. 7.2. Push together plug connections for rear wire harness to main wire harness -arrows B-  and lock until they are felt to engage.
    Fig 4: Pushing Together Rear Wire Harness To Main Wire Harness Plug Connections
    G09593846Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  8. Push together plug connection for rear wire harness to engine wire harness -1-  .
    1. 8.1. Push connector socket for rear wire harness onto relay carrier -arrow A-  until it is felt to engage.
    2. 8.2. Push together plug connection for rear wire harness to engine wire harness -arrow B-  until it is felt to engage.
    Fig 5: Pushing Together Rear Wire Harness To Engine Wire Harness Plug Connection
    G09593847Courtesy of PORSCHE CARS NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals