Installing Clutch
WARNING: This page is about a different variant/trim than selected.
- Insert the centring mandrel 3176
with the drive plate into the guide joint (needle sleeve).
Information
- Clean the friction surfaces of the flywheel and clutch pressure plate prior to installation with brake cleaner or solvent naphtha.
- Surfaces of friction linings must be free from contamination, especially oil and grease.
Information
To avoid deforming the clutch pressure plate, tighten fastening screws in at least 5 steps and in diametrically opposite sequence. Always replace fastening screws.
- Install pressure plate.
Location Description Type Basic value Tolerance 1 Tolerance 2 Clutch pressure plate Initial tightening 15 Nm (11 ftlb.) Clutch pressure plate Torque angle 45° - Remove centring mandrel for toothed segment 9538/1.