Fitting Accessories
WARNING: This page is about a different variant/trim than selected.
- Fit mount for exhaust system on transmission.
Location Description Type Basic value Tolerance 1 Tolerance 2 Exhaust system mount Fastening screws between transmission housing mount Tightening torque 45 Nm (33 ftlb.) - Push on electric connector for reverse gear switch.
Information
Before installing the clutch slave cylinder, grease the push rod with Kluberalfa in the area of the release-lever ball socket. Part No. 000.043.304.02 (50g tube).
- Insert clutch slave cylinder in transmission opening and screw in fastening screw.
Location Description Type Basic value Tolerance 1 Tolerance 2 Clutch slave cylinder Fastening screws between transmission housing and clutch slave cylinder Tightening torque 23 Nm (17 ftlb.) - Fit the external shift mechanism and tighten nut.
Location Description Type Basic value Tolerance 1 Tolerance 2 External shift mechanism Fastening nut between shifting shaft and external shift mechanism Tightening torque 23 Nm (17 ftlb.)