Technical Values
WARNING: This page is about a different variant/trim than selected.
| Location | Description | Type | Basic value | Tolerance 1 | Tolerance 2 |
|---|---|---|---|---|---|
| Transmission/engine connection | Hexagon-head bolt no. 1 in illustration, M12 x 70 | Tightening torque | 85 Nm (63 ftlb.) | ||
| Transmission/engine connection | Hexagon-head bolt no. 2 in illustration, M12 x 100; with washer | Tightening torque | 85 Nm (63 ftlb.) | ||
| Transmission-engine connection | Hexagon bolt No. 3 M12 x 90 in illustration | Tightening torque | 85 Nm (63 ftlb.) | ||
| Transmission-engine connection | Internal serration screw No. 4 M10 x 35 in illustration | Tightening torque | 45 Nm (33 ftlb.) | ||
| Transmission-engine connection | Nut No. 5 M10 in illustration | Tightening torque | 45 Nm (33 ftlb) | ||
| Transmission/engine connection | Hexagon-head bolt no. 6 in illustration, M12 x 90 | Tightening torque | 85 Nm (63 ftlb.) | ||
| Transmission-engine connection | Hexagon bolt No. 7 M12 x 90 in illustration | Tightening torque | 85 Nm (63 ftlb.) | ||
| Clutch slave cylinder | Fastening screw between transmission housing and clutch slave cylinder | Tightening torque | 23 Nm (17 ftlb.) | ||
| Transmission support | Fastening screws between transmission support and transmission | Tightening torque | 65 Nm (43 ftlb.) | ||
| Hydraulic mount | Fastening screws between hydraulic mount and body | Tightening torque | 33 Nm (24 ftlb.) | ||
| Cross member | Fastening screws between cross member and body | Tightening torque | 65 Nm (48 ftlb.) | ||
| Drive shafts | Fastening screws between drive shaft and transmission flange | Tightening torque | 81 Nm (60 ftlb.) | ||
| Anti-roll bar | Fastening screws between anti-roll bar and rear axle carrier side member | Tightening torque | 23 Nm (17 ftlb.) | ||
| Restraining cable | Fastening nut between restraining cable and cross member | Tightening torque | 23 Nm (17 ftlb.) |