LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2009 >> Cayman Base, Automatic DCT >> Repair and Diagnosis >> External Pages >> Different car >> Section 1 (61 - Convertible Top, Hardtop -- 987-BOXSTER) >> WM 612855 Replacing Convertible-Top Covering (BOXSTER SPYDER) >> Assembling Convertible-Top Covering >> Installing Upper/Lower Part Of Tenax Fastener

Installing Upper/Lower Part Of Tenax Fastener

WARNING: This page is about a different car, the 2012 Porsche Boxster, 2011 Porsche Boxster, 2010 Porsche Boxster, 2009 Porsche Boxster, and 2008 Porsche Boxster. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install upper part of Tenax fastener.
    1. 1.1. Position upper part of Tenax fastener -2-  in the hole provided for this purpose on the weather protector -3-  .
    2. 1.2. Screw in twist lock -1-  slightly by hand.
    3. 1.3. Counter upper part of Tenax fastener -2-  with your hand and tighten with the Seeger circlip ring pliers -arrow-  .
      4. Fig 1: Installing Upper Part Of Tenax Fastener
      G09590236Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  2. Install lower part of Tenax fastener.
    Fig 2: Installing Lower Part Of Tenax Fastener
    G09590237Courtesy of PORSCHE CARS NORTH AMERICA, INC.
    1. 2.1. Position lower part of Tenax fastener in the hole provided for this purpose on the hood covering.
    2. 2.2. Screw in twist lock slightly by hand and then tighten with the Seeger circlip ring pliers -arrow-  .
scientia non olet · About LEMON Manuals