Installing Right Water Drip Pan

WARNING: This page is about a different car, the 2012 Porsche Boxster, 2011 Porsche Boxster, 2010 Porsche Boxster, 2009 Porsche Boxster, and 2008 Porsche Boxster. However, it is still accessible from the selected car via links, so may be relevant.

Information

When installing the water drip pan, make sure that the rear part of the water drip pan is fitted under the seal and the front outer part is fitted under the water drain plate.

Position water drip pan -1- on the body and align it -arrows- .

Fig 1: Installing Water Drip Pan (Right Side)
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Check that the water drain is seated correctly.
Position tensioning element -3- on the water drip pan or roll-over bar -arrow- and secure with the fastening screws -1, 2- . → Tightening torque: 23 Nm (17 ftlb.)

Fig 2: Installing Tensioning Element
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Detach the red tensioning lever -1- on the right-hand side of the vehicle. To do this, press the release handle on the underside of the tensioning lever.
Engage the retaining eyelet for the tensioning cable -2- at the fastening hooks on the tensioning lever.
Press the tensioning lever -1- down until it locks with an audible click.

Fig 3: Detaching Red Tensioning Lever

Courtesy of PORSCHE CARS NORTH AMERICA, INC.