Installing The Electrohydraulic Control Unit
WARNING: This page is about a different variant/trim than selected.
Information
- Screws which are tightened with a torque angle must be replaced with new ones.
Information
- The adaptation values of the Tiptronic control unit must be reset using the Porsche System Tester when replacing/exchanging the electrohydraulic control unit. → Removing and installing the Tiptronic control unit
- Install electrohydraulic control unit. To do this, screw in new fastening screws -Pfeil- . → Initial tightening: 6 ftlb. → Final tightening: 90 degree angle