Removing ATF Cooler
WARNING: This page is about a different variant/trim than selected.
- Remove the front transverse strut under the coolers. To do this, loosen the two fastening screws (M8 x 25) at the left and right.
- Danger of scalding
- Place oil collection pan under the ATF thermostat.
- Unscrew nut on ATF line to thermostat -arrow - and drain ATF.
- Close off line ends.
- Remove retaining clip -arrow - on ATF cooler.
- Remove ATF cooler.
WARNING:
Hot fluid
→ Let the fluid cool down.
→ Wear personal protective gear.