Installing ATF Cooler

WARNING: This page is about a different variant/trim than selected.

Fig 1: Overview Of ATF Thermostat

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Fig 2: Retaining Clip On ATF Cooler

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Fig 3: ATF Cooler

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Screw on nuts securing ATF line to thermostat -arrow - → Tightening torque: 30 Nm

Fig 4: Transverse Strut To Body

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Install the front cross member under the coolers. To do this, tighten the four fastening screws. → Tightening torque: 23 Nm (17 ftlb.)
Unscrew ATF control screw -A - and fill in ATF until a constant discharge is visible at the lifting tube.
Screw in ATF inspection plug with a new sealing ring. → Tightening torque: 70 Nm (52 ftlb.)

Fig 5: Identifying Oil Inspection Plug And Oil Drain Plug
Courtesy of PORSCHE CARS NORTH AMERICA, INC.