Subsequent Work For Transmission Mount

WARNING: This page is about a different variant/trim than selected.

Information

Always observe the exact work sequence when installing/removing the transmission cross member.

Information

Screws which are tightened with a torque angle must be replaced with new ones.

Install transmission cross member.
Screw in two transmission cross member screws -B- on the transfer gear holder. → Initial tightening: 50 Nm (37 ft lbs.) → Final tightening: 90°

Fig 1: Identifying Transmission Cross Member
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Screw in fastening screws for securing transmission cross member to body -A- . → Initial tightening: 50 Nm (37 ft lbs.) → Final tightening: 90°