Installing Transmission Mount

WARNING: This page is about a different variant/trim than selected.

Insert new rubber mounting in tool T10214/2 (calibrating sleeve) . Place tool T10214/3 on the plastic ring of the mount without screwing it to the mount.

Fig 1: Inserting Rubber Mounting On Tool T10214/2 (Calibrating Sleeve)
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Press the transmission mount on the workshop press into tool T10214/2 (calibrating sleeve) until it is flush -arrows- with the upper edge. The tool T10214/1 -1- must be placed underneath.

Fig 2: Calibrating Transmission Mount
Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Information

If tool T10214/3 is not screwed to the mount, this can damage the tool.
Screw tool T10214/3 to the calibrated mount.

Fig 3: Screwing On Tool
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Tool T10214/3 together with the new mount must be positioned on the transmission cross member. The notch on the special tool -arrow- must be aligned with the marking -arrow- on the transmission cross member before being removed.

Fig 4: Aligning Transmission Mount
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Press the calibrated mount -2- into the transmission cross member using the workshop press. When doing so, make sure the mount is aligned with the transmission cross member.

Fig 5: Pressing Transmission Mount
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
1. 5.1. To do this, place tool T10214/1 under the opening in the transmission cross member. The mount is at the correct installation position when the tool T10214/2 can move freely.
  
  Fig 6: Moving Tool Freely
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Unscrew tool T10214/3 from the mount.

Fig 7: Unscrewing Tool
Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Information

When pressing in the mount, the mount may not be seated evenly in the transmission cross member.
Tool T10214/3 must be repositioned on the projecting side and the mount must be pressed in flush until it is installed evenly in the transmission cross member.