Assembling Cover For Selector Lever

Information 

• Use a clean and soft working surface to disassemble the cover for the selector lever. 

1. Before assembly, the printed circuit board is to be inserted correctly -arrows-  .
   Fig 1: Locating Printed Circuit Board Fastening Screws

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
2. The shade must be inserted in the correct position, sliding contact -1-  on grinding track -2-  .
   Fig 2: Identifying Position Of Upper Part To Lower Part

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
3. Fasten shade on the one side with the retaining lugs -arrows-  .
   Fig 3: Inserting Shade

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
4. Push shade onto the upper part, fastening the shade until it locks with an audible click.
   Fig 4: Pushing Shade Onto Upper Part

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.