Installing Rear Brake Disc

Do not confuse right and left brake discs during assembly!

Distinguishing characteristic: Part No.! The flat surface of the brake discs is marked with R = right or L = left.

1. Check that all parts are in perfect condition and replace them if necessary.
2. Clean the levelling and centring surfaces on the brake disc and wheel hub. Then apply a very thin coat of Optimoly TA to the centring surface on the wheel hub.
3. Fit the brake disc. Observe tightening torque. → WM 4600TW TIGHTENING TORQUES FOR BRAKE MECHANICS  .
   Fig 1: Identifying Brake Disc

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
4. Adjust the brake shoes of the foot-operated parking brake with a → see Fig 2 screwdriver.
   Fig 2: Adjusting Brake Shoes Of Foot-Operated Parking Brake Using Screwdriver

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
5. Fit the brake calliper. Replace the brake calliper fastening screws following removal. Observe tightening torque. → WM 4600TW TIGHTENING TORQUES FOR BRAKE MECHANICS  .
6. Position disc brake pads by operating the brake several times.
7. Check brake fluid level and correct it if necessary. The brake fluid level must be within the → see Fig 3 MIN/MAX marking.
   Fig 3: Identifying Brake Fluid Reservoir Marking

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.