Removing Number Plate Light

→ Remove ignition key.

→ Turn off switches.

77 Information 

• Before removing the number plate lights, take out the ignition key and switch the light switch off. The plug connection must point towards the inside of the vehicle. 
• The removal and installation of number plate lights in vehicles with an externally located spare wheel mount is described in the section on disassembling and assembling the rear apron  . → WM 635537 DISASSEMBLING AND ASSEMBLING REAR APRON

1. Remove number plate light:
   1. 1.1. Loosen the two sheetmetal screws and remove the number plate light together with the sheetmetal screws.
   2. 1.2. Actuate the connector and disconnect.
      Fig 1: Removing Number Plate Light

      Courtesy of PORSCHE CARS NORTH AMERICA, INC.
2. Removing bulb for number plate light:
   1. 2.1. Press the mounting for the bulb apart and remove the bulb -arrowrichtung-  from the holder.
      Fig 2: Removing Bulb For Number Plate Light

      Courtesy of PORSCHE CARS NORTH AMERICA, INC.