Adjusting Headlight Mounting
- Move the main headlight -arrows A, B, C-
to align it to the contour of the wing -Arrows-
. → Gap dimension: 3 mm
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
- Maintain the prescribed gap dimension of the front guide rail for the front apron. → Installing front apron
- First tighten the two screws at the front -2-
, then the two at the back -1-
and check the gap dimension. Loosen the headlight mounting if necessary and re-adjust it. → Tightening torque: 7 Nm (5.0 ftlb.)+/-0.5 Nm (+/-0.5 ftlb.)
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
- Remove and install the main headlight at least 3 times, then check the gap dimension again. Re-adjust the headlight mounting if necessary.