Installing Toe Control Arm

Observe correct tightening torques. → Tightening Torques For Rear Axle 

1. 1.1. Install eccentric threaded joint (toe control arm) on the rear-axle carrier side section.

   Set the basic position of the toe eccentrics at the marked position on the rear-axle carrier side section and tighten lock nuts.

2. 1.2. Fit toe control arm -1-  on the wheel bearing housing -1b-  .

Fig 1: Identifying Rear Toe And Transverse Control Arm

Courtesy of PORSCHE CARS NORTH AMERICA, INC.